MakerMondo

Every 3D printing enthusiast knows the frustration: your print stuck perfectly to the bed, but now it refuses to come off. Grabbing a standard hardware store putty knife or kitchen tool usually results in gouged build surfaces, chipped glass, or sliced prints (and fingers).

The BuildTak Spatula was engineered from the ground up specifically for the FFF/FDM 3D printing world. It eliminates the struggle of part removal, allowing you to safely lift your finished prints with minimal force.

Unlike thick DIY scrapers, the front edge of this blade is micro-thinned to slide effortlessly under the raft, brim, or base of your print without catching or ripping your print bed sheet.

The non-slip rubber grip gives you absolute tactile control and maximum leverage, keeping your hands safe from accidental slips.

• Easily remove your objects from the 3D printing platform
• Optimised design for FFF / FDM 3D printing
• Plastic handle with non-slip and ergonomic rubber grip
• Blade of rigid stainless steel
• 250 mm