UltiMaker Sliding Block Pack (UM3, 2+C) 70-232042

€60.50excl. VAT

€73.21incl. VAT

UltiMaker sliding block and belt pack for UM3 and 2+ Connect (70-232042). Includes 4 sliding blocks, 4 long gantry belts (616 mm), and 2 short motor belts (200 mm),

On backorder

2–3 weeks

Description

Sliding block and belt pack for UltiMaker 3 and 2+ Connect

The sliding block pack is a comprehensive gantry maintenance kit designed to restore the mechanical precision of your UltiMaker’s motion system. These sliding blocks serve as the critical linkage between the X and Y axes, housing the bushings that glide along the linear shafts. Over time, the internal bushings can wear or the timing belts can lose tension, leading to "backlash," ghosting, or a loss of dimensional accuracy. This pack provides all the high-wear components required to refresh your printer's drive system.

What is in the pack?

4x Complete sliding block assemblies: Pre-assembled housings that secure the timing belts and provide the sliding interface for the 8mm shafts.
4x 616 mm GT2 belts: The primary long timing belts that drive the X and Y axes, specifically measured for the UM3 and 2+ Connect gantry.
2x 200 mm Short belts: Reinforced drive belts that connect the X and Y stepper motors to the main drive rods.

Compatibility:

This gantry service pack is designed for the following models:

UltiMaker 3 and 3 Extended
UltiMaker 2+ Connect